Wybron Coloram II Uživatelský manuál stáhnout pdf (Strana 8)

Menu Details

The following is an explanation of functions and optional settings which are

accessed via the various menus displayed.

1. POWER UP SCREENS

When you connect the power supply to AC power, the following screens will

appear on the display.

1. The INTRODUCTION screen will scroll through the software version and

other information.

2. The ROLLCALL screen shows when the power supply interrogates the

color changers and other components connected to the power supply. This

is the time the color changers "check in" with the power supply.

2. RUN SCREEN LOOP

The display alternates between three screens.

The first is " 1 -- X " where X is highest DMX channel used by a color

changer (or other component) connected to the power supply. If talkback is

ON, X will be the highest DMX channel used by the talkback function.

The second screen is " DMX OK " if the DMX signal is being properly

received. It is " NO DMX " if the DMX signal is not being properly received.

The third screen is " *ALERTS* " if there are any alert conditions to report.

3. ALERTS / ERROR MESSAGES

The power supply will display "alert messages" indicating a condition a service

person may want to know about.

The alert messages and meanings are as follows:

Note: the "xxx" after each message is the DMX channel to which the message

applies.

"Pstn xxx" - Gel position error - a difference exists between the commanded

gel position and the actual gel position.

"VDC xxx" - Color changer voltage is below 17 volts DC.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Žádné komentáře

Wybron Coloram II Uživatelský manuál Strana 8