Wybron Coloram II Uživatelský manuál stáhnout pdf (Strana 10)

Coloram IT User Manual

Revised March 2009

Page 10

Installing the Coloram IT

1. Attach the color changer to the fixture

Slide the color changer's mounting bracket into the gel frame holder of the fixture and

lock the gel frame retention clip (if available). If the mounting plate installed on the color

changer does not fit the fixture, you may be able to replace it with the Wybron Universal

Mounting Plate.

The mounting plate allows you to position the

color changer with the gelstring rolling either

horizontally or vertically. However, Coloram IT

operates most effectively with the fan, which is

located in the top of the center panel, blowing air

vertically (as hot air naturally rises).

2. Attach the safety cable

A safety cable is attached to the color changer.

Run this cable around the pipe or truss from

which you hang the light fixture and clip it to

itself.

3. Mount the power supply

The PS Power Supply is designed to be freestanding, truss-mounted, or rack-mounted.

The Power Supply comes with a mounting bracket that hooks over the pipe or truss of

your lighting rig and is then locked into place with a thumb screw. With this mounting

method, connect the safety cable by running it around the pipe or truss to which the

power supply is attached.

The power supply can also be mounted into a 19" rack using the optional PS Power

Supply rack mount kit. The rack mount kit will accommodate two PS units side-by-side.

4. Connect the color changers to the power supply

Connect the color changers to the power supply using 4-pin cable. Refer to the Head-

Feet Restrictions section of this manual for details regarding the length of cable runs.

5. Connect the power supply to AC power

Plug the AC cord into a non-dimmed power circuit. The power supply automatically

accommodates 100 - 240 VAC (50/60 Hz). Power at the PS Power Supply is indicated by

a red LED indicator.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Žádné komentáře

Wybron Coloram II Uživatelský manuál Strana 10